First off, credit goes to A.C.E. for making the original one. He created it
WAY before me. Also, this is only cosmetics, it WILL NOT cover anything for range
Materials3B handle
Nite Finder
Epoxy Putty
Hot glue
First, get your 3B handle and cut it here:
Put your 3B handle aside for a while and get your Nite Finder. Take out all of the internals and cut it here:
(You may want to sand away the curve left from the handle)
Now take your handle and hot glue it onto your Nite Finder shell (make sure that you can still open the gun up)
Now try your best to get it level by sanding. (You CAN'T cut off the NERF symbol, it won't work)
Now, to save Epoxy Putty, try to level it out with hot glue.
(I got it around the symbol)
Now, it's time to give your handle some strength and make more things level. Get your Epoxy Putty and glue down the handle and make everything smooth.
I don't have a picture of this, but the trigger won't actually work until you Dremel a hole in the handle fot it to slide through, but even after that it won't work! cut down your trigger to make it fit and them curve it with yout dremel (or create a new, smaller trigger).
Now, screw down the trigger and glue the trigger spring to the shell.
Put your internals in and it should look very strange.
Close the gun up and... your still not done. Fill those holes in the shell that let you see the plunger tube with hot glue
Paint it and your done!
Edit:
Again, credit goes to A.C.E. for making the original.
My video!----------------------------------------------------------------------------------------------------------------------------------------------------------------
This was a later post on most sites.
Yesterday I was bored and decided to redo a lot of it.
MaterialsBondo
Paint
E-tape
Hot Glue
K26 spring
Really thin plastic sheet (1/16 polycarb may work, but the thinner is better.)
First off, it doesn't look the nicest or the cleanest, so I decided to Bondo it and smooth it out.
Now you are going to want to gut out some of your plastic sheet so that it fills the gaps left from cutting, and them hot glue them down.
I know I never really mentioned anything about power in the first post, but this is really boost your ranges. Put two wraps of e-tape under the O-ring and add another O-ring (almost identical) and you will have a perfect seal (and if you want any super lube, PM me.) Next cut down a K26 to the length of the stock spring and you will get this:
Now here comes the really fun part-painting!!! But down whatever color you want:
and then start detailing!!! Do whatever you want until it looks good or you get what you want! Here is my finished product.
Closeup on epic handle detailing:
Epic gap sealing:
This thing worked its way into being my favorite once again! I love this thing so much, and the ranges are right around 50ft. with slugs.