Alright, time for the first homemade of the new year!
As you may remember, I took the SNAP, and I made it my size, also know as awesomely big. This turned out a little "eh". Well, this time I took the PVAT 2.0, also known as VenPVAT, and made it awesomely big, and dubbed it the "Epic PVAT", and this is the writeup.
First, the whole safety rant: Never use globbity plastic cements, always wear eye protection, protection is important, and wear a respirator when exposed to fumes. Always use a vice to hold your junk, not your or other people's hands. Now, onward!
First, stuff needed!
Stuff you need from this pic is the 1/4" bolt(preferably carriage), 5/8L beveled faucet washer, 3/16" ID x 5/16" OD orings, 1/8" pipe nipple(needs to be hex), 1/2" to 1/8" bushing, 2" to 1/2" bushing x2, 2" coupler. Not pictured: 1/8" cap, strong spring, spacer.
First, sand the smooth part of your bolt. I did this by placing it in the chuck of a drill and spinning it while holding sandpaper to it. Sand until the nipple slides easily along the bolt.
Assemble the rear of your PVAT like so, using teflon tape between threaded connections, and PVC cement between slip joints.
Drill out your 1/8" cap with a 1/4" bit.
Drill a 7/16" hole in the side of the tank.
Tap the hole with a 1/4" NPT tap.
Yeah, I tapped that!
Assemble your pin setup.
Assemble the tank with a 1/4" fitting in the tapped hole. Add a pump, and your good to go!
You now have an EPVAT!
Ranges are as of yet undetermined. I'm having sealing problems. First was the rear seal, due to the wrong sized orings, then was the front, due to wrong sized faucet washer, the front again, leaking between the bolt and nut holding the washer on, and now slightly around the edge of washer. I have found some interesting washer thingies in the faucet repair aisle of my hardware store, so might be looking in to stuff.
Also, lithium grease is the suggested lubrication method. I happen to have a can of liquid wrench lithium grease, so good to go.